Equipment Hatches help your company maintain your competitive advantage with minimal downtime during retooling operations.
Equipment Hatch Roof Curbs
Need to be able to swap equipment in and out of a building? Our Equipment hatches are here to help!
Today, many companies are swapping out or updating equipment to maintain a competitive advantage. SSM can help your company have a competitive advantage on the construction side too.
As one of the country’s premier roof curb manufacturers, we offer a one piece solution that is complete and easy to install. Lifting hooks are built into the system making the installation sequence simpler to execute.
And that provides your customer with a roof curb that will allow them to easily remove older equipment and stay competitive.
For an even greater advantage, select a model with an integral roof curb component and you can add a skylight or install HVAC equipment on top of the assembly.
For more information or assistance, fill out the form on the left to tell us about your roof curb project, we will get back to you shortly. You can also contact Derek Mills directly via e-mail: firstname.lastname@example.org or by giving him a call: 816.627.5437.
SSM‘s Roof Curb Installation Guide
By selecting our hybrid roof curb, you have selected a patented (US Patent #US 9546485B2) and proven product that is easy to install.
With decades of experience and thousands of roof curbs under our belt, it is no wonder we are able to continue to innovate and improve our hybrid roof curbs.
There are dozens of roof curbs on the market today, but what sets SSM apart is the attention to detail and the continuous evolution of our patented design.
SSM offers a one-of-a-kind patented (US Patent #US 9546485B2) roof curb that comes in one piece with no assembly required making for easy install.
1. 24 gauge Galvalume®, welded cap is part of our patented design.
2. Integral water diverter cricket.
3. Except as noted, our components are 18 ga. Galvalume®. Our
standard Top Flange is 1 1/2” wide but this can vary depending upon your job requirements.
4. Standard height is 10”and sloped to the roof pitch to provide a level mounting surface, based upon your project’s specific needs.
5. The bottom flange, found on 3 sides, is also 1 1/2” wide but custom widths are available.
6. The interior of the Cricket is full enclosed and insulated.
7. Pre-laid out fastener holes, 9/32” in diameter, are placed at 3” [max.] centers around the full curb perimeter.
8. Purlins, enhance stability of the roof, improving both safety and performance.
Engineered for ease of Installation, SSM‘s one piece hybrid curb solution is designed to make installation easy.
B] Cut the opening needed and trim back the roof’s standing seam components as needed for the curb to seat properly.
C] Clean the area around the opening to remove loose particles.
E] Trim all excess butyl and check to see that the tape is secure.
F] Remove the backing layer from the tape and flip the hybrid roof curb over – holding it above the roof opening – and check for proper alignment.
I] Clean up the area around the opening joint between hybrid curb and roof to remove any loose particles.
J] Apply caulk around the perimeter of the hybrid curb in an even and concise manner, utilizing the proper tools, to ensure a consistent seal.
That is it! You are ready to move on to the next one!